|
Product Details:
|
| Board Density: | 1.2-1.6g/cm3 | Compressive Strength: | 20-30MPa |
|---|---|---|---|
| Flexural Strength: | 7-12MPa | Water Absorption: | Not More Than 10 Percent |
| Thickness: | 3-25mm | Siliceous Material: | Milled Quartz Sand |
| Curing: | Autoclave 1.0-1.2MPa | Installed Power: | About 245kW |
| Highlight: | quartz sand cement board line,high density fiber cement machine,20Mpa compressive board line |
||
Quartz sand gives the most consistent board of any siliceous raw material, and buyers in Vietnam, Thailand and southern China keep coming back to it when their customers demand high density and a compressive strength figure above 20 MPa. This line is configured for quartz based calcium silicate production: ball mill or roller mill feeding, precise lime to quartz ratio control, autoclave curing at 1.0 to 1.2 MPa, and a pressing and calibration section that brings board density into the 1.2 to 1.6 gram per cubic centimeter range. The result is a sheet that machines cleanly, holds a screw without crumbling and takes a thin coat finish without sanding through the densified skin. Since 1996 we have built this type of line for buyers who intend to compete on technical data rather than on price alone.
Key Features| Parameter | Specification |
|---|---|
| Board density | 1.2 to 1.6 gram per cubic centimeter |
| Compressive strength | 20 to 30 MPa typical |
| Flexural strength | 7 to 12 MPa |
| Water absorption | Not more than 10 percent, 24 hour immersion |
| Board size | 1220 x 2440 mm |
| Thickness range | 3 mm to 25 mm |
| Siliceous material | Quartz sand, milled to controlled fineness |
| Curing | Autoclave 1.0 to 1.2 MPa |
| Installed power | About 245 kW including milling |
| Annual capacity | 3 to 10 million sqm |
Dense quartz based board is specified where the surface is exposed and the fixing must hold: exterior cladding with visible joints, balcony soffits, wet area walls in hotels, laboratory bench substrate, and floor panels in raised access floor systems. In Vietnam and Thailand the same board is used for facade cladding on mid rise buildings where a rendered finish would fail in the monsoon, and for ceiling panels in corridors of condominiums where a smooth factory finish reduces site labour. Buyers selling into Australia and the Middle East often ask for the higher density end of the range because their own test requirements for screw pull out and impact resistance are stricter than the local standard.
Packaging & Quality AssuranceThe milling circuit ships as a separate module with the classifier and fan crated individually, and the mill liners are protected against corrosion during sea transit. Autoclave shells travel with all nozzles capped and the door ring greased and covered. Documentation includes material certificates, mill alignment records, autoclave test reports and the density and strength test data from our trial runs. We provide a one year warranty on wearing parts, mill liner wear allowances in the first year spares kit, and a three year spare parts price hold. Commissioning normally takes twenty days and includes a full test matrix across three densities so the buyer leaves with proven recipes for each product in the catalogue.
Contact Person: Kevin
Tel: 86-18254101233
Fax: 86-531-82985999